V9: Heavy Padding

From AmtWiki
Revision as of 16:57, 22 December 2022 by BlackBart (talk | contribs)
221202---V9-Rules-Seal-for-Wiki.png
This page is part of the Official Amtgard V9 Alpha-Playtest Rulebook.
  • The Amtwiki is the official home and primary source for Amtgard V9 Rules as of February 25, 2023.
  • These rules are currently in Open Alpha Playtest. See the Playtest Disclaimer for more details.
  • To learn more about Amtgard V9 Development, please visit Amtgard.com.
  • To view the current Amtgard V8 ruleset, please see the Amtgard V8 Rulebook.




Heavy Padding

Slash-Legal Padding with an edge-to-edge cross section of 4” or greater is automatically considered Heavy Padding.

  1. Heavy Padding added must start within 3” of the Striking Tip and proceed continuously towards the handle.
  2. Heavy Padding Substitution: For each inch of Heavy Padding added you may replace one (1) inch of required Slash-Legal Padding with Incidental Padding. Incidental Padding added in this manner must begin by replacing the Slash-Legal closest to the handle and then proceed continuously towards the Striking Tip. A weapon cannot substitute more than 50% of its Slash-Legal surfaces this way.
A 48” Long weapon would typically have 32” of Strike-Legal followed by 16” of handle and pommel. Using Heavy Padding Substitution you could have 16” of Heavy Padding, followed by 16” of Incidental Padding, and then 16” of Handle.

Template:V9 Strike Legal Rules